Electro-Voice Zx1i-100T Manuel du propriétaire télécharger pdf (Page 8)

8 Electro-Voice

Zx1i Owner’s Manual

Step 4: Attach the Speaker to the QuickSAM™ Bracket

After mounting the QuickSAM

bracket (from Step 1) to the desired surface, attach the

speaker to the QuickSAM

bracket by inserting the QuickSAM

into slot on the side of

the speaker until it “clicks” in place. Using the provided mounting tool, tighten the two

socket head bolts A and B enough to allow aiming, as shown in Figure 9. After selecting

the proper horizontal angle, secure the sweep axis as shown by tightening bolt A. Next,

select the proper vertical angle and secure the rotation axis by tightening bolt B. To

tighten the recessed bolt B, insert mounting tool through hole on the side of the speaker.

Figure 9: Attaching Speaker to QuickSAM

Assembly

QuickSAM

Assembly

Enclosure

Socket Head Bolt B

(Recessed Inside

Hole)

Socket Head

Bolt A

Mounting Tab

WARNING: Bolt “B” is what secures the speaker to the

QuickSAM

Bracket. It is the installer’s responsibility to

ensure that Bolt “B” is fully tightened. Failure to tighten Bolt

“B” may allow the speaker to disengage from the

QuickSAM

Bracket, possibly resulting in serious injury. Use

of the Seismic restraint is highly recommended. See Step 6.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Electro-Voice Zx1i-100T Manuel du propriétaire Page 8